Instructions / Assembly

INSTALLATION HINTS
3
1
2
DRICORE Insul-Armor is a high density EPS
foam substrate. It cuts easily with a utility
knife with 2 or 3 scores. Be sure not to cut
the panels on a finished surface as the
knife blade will go through the foam
completely.
3
To protect your wall framing from moisture
coming through the concrete slap, it is
recommended to install DRICORE
Insul-Armor directly beneath your framing.
Cut strips of DRICORE Insul-Armor 3 1/2"
wide, and install these strips beneath your
wall framing. Remember to allow an
additional 1" of space for DRICORE
Insul-Armor panels when building walls.
DRICORE Insul-Armor should be installed at
the same time as the installation of the
finished floor.
In the event that damage does happen to
the DRICORE Insul-Armor panels after being
installed, simply cut out the damaged area,
replace with a fitted piece matching the
cutout dimensions, and tape the seams
using a vapor barrier rated tape (available
at buidling supply stores in the vapor
barrier section).
A
B C
© AGT Products (IP) Inc. DRICORE
®
is a registered trademark of AGT Products (IP) Inc. used under license by AGT Products Inc. and AGT
Products (USA) Inc. 1-866-767-6374