Instructions / Assembly

INSTALLATION PROCESS

While you can lay the DRICORE Insul-Armor panels in

either direction, it is generally laid with the 4' length

running the longest dimension of the room.

Start with a full panel with the grooved edges against the

finished walls. Leave a 1/4" of space (for expansion) on

rooms less than 20' long, and 1/2" for rooms longer than 20'.

Install the first row of panels until you reach the end of

that row, trimming the last panel to fit. If the resulting

cut-off is greater than 18" long, you can use it to start the

next run of panels. Make sure you install shims between

the DRICORE Insul-Armor panels and the finished walls, so

panels don't shift during installation.. Some installers

prefer taping the joints of the panels with a vapor barrier

rated tape to help hold the panels in the first 1-2 rows

together during installation.

Once the first row of DRICORE Insul-Armor is installed, we

recommend laying your choice of hard surface floors

immediately on the newly installed row of Insul-Armor

(reference Installation Hint #1 for details). We will

address carpet installations in the carpet section.

NOTE: For carpet installations, skip to the Carpet

Installation section 4B, on page 7.

is a registered trademark of AGT Products (IP) Inc. used under license by AGT Products Inc. and AGT

Products (USA) Inc. 1-866-767-6374