TDS

7. APPLICATION TEMPERATURE

Substrate and ambient air temperature between 50°F and 100°F ( 6°C and 38°C) to be maintained thru the curing period.

8. CONDITION PRODUCT

Condition cartridge and contents to a temperature of 65°F to 85°F (18°C to 29°C) for easier dispensing.

9. LIMITATIONS & WARNINGS

Do not thin. Solvents will prevent proper cure.

10. MANUFACTURER’S PRINTED INSTALLATION INSTRUCTIONS

11. SURFACE PREPARATION

12. CLEAN UP

Clean tools and equipment with Mighty Wipes by Dricore, a biodegradable formula that removes and neutralizes the epoxy. Do not allow

epoxy to harden on equipment as cured material can only be removed mechanically.

13. SAFETY

Please refer to the SDS for DRICORE™ PRO Concrete Repair Saturant-Adhesive Epoxy published on our website, www.dricore.com or call

Dricore for more information at 1-866-767-6374. This TDS sheet is not intended to list all Safety and Health Requirements necessary for the

installation of these products. All Health and Safety Requirements required by OSHA shall be followed.

14. WARRANTY

Dricore warrants to the Buyer that this product is in good quality and conforms to the manufacturer’s specifications in force on the date

of manufacturer when used in accordance with the Installation Instructions and when stored as directed in the technical literature.

Manufacturer cannot warrant or guarantee any particular method of use, performance or application under any particular condition and

Buyer is responsible for determining the suitability of intended purpose and assumes all risks therein. Dricore shall not be liable for any

injury, loss, cost of labor or consequential damages either directly, indirectly or incidentally, arising out of the use or misuse of any

product sold by Dricore or another distributor. If the product is proven to be in non-conformance, the Buyers sole remedy shall be a

refund of the purchase price or replacement of product.

DRICORE™ PRO Concrete Repair Saturant-Adhesive Epoxy | Revision Date 09/25/2020

TECHNICAL DATA SHEET

2311 Royal Windsor Drive Unit 2

Mississauga, Ontario, Canada L5J 1K5

P: +1 866 767 6374

E: info@dricore.com

1-866-767-6374 | www.Dricore.com

For complete installation instructions on various applications using DRICORE™ PRO Concrete Repair Saturant-Adhesive Epoxy, visit

www.dricore.com or call Dricore for more information at 1-866-767-6374.

DRICORE™ PRO Concrete Repair Saturant-Adhesive Epoxy is specially formulated for use as a saturant epoxy for CFRP. New concrete

must be a minimum of 28 days old. Surfaces must be clean of all dirt, oil, debris, wax, grease or dust must be removed. Prepare the

surface mechanically using a scarifier, sand blast, shot blast, bush hammer or other equipment that will provide a minimum surface

profile of CSP3, as defined by ICRI 310.2R. A roughened surface that exposes the aggregate and/or pores of the substrate is imperative

for good adhesion.