Instructions / Assembly

1)Remove the Blue Cap from the pressure tank,
install the Water Tank Control Valve, as shown in
Figure A-7.
2)Connect the other end of the Red RO Tubing
into the Water Tank Control Valve,as shown in
Figure A-7.
Red RO Tubing Connection:
1)First remove the connected White RO Tubing, then use supplied wrench to unlock the RO
Membrane Cap, as shown in Figure A-8.
2)Get the RO Membrane out of the sealed package and insert the RO Membrane inside the
RO Membrane housing. Screw the cap back on, re-connect the White RO Tubing, direction as
shown in Figure A-8.
3)Install the filter housing back onto the RO system. First turn on the Flush Valve, then turn on
the Water Shut-off Valve.
4)Flush the new filters for over 15 minutes to condition the new replaced filters, then turn off
the Flush Valve.
1)Remove the Blue Collar Clip, pull the Red Protective Cap out of the Tee connector.
2)Insert the supplied Red RO Tubing to the Tee connector, install the Blue Collar Clip back on.
3)Connect the other side of the Red RO Tubing into the Tank Shut-off Valve, as shown in
System Diagram.
Install Reverse Osmosis Membrane
*The bottom 3 Stage Pre-filtration system`s tubing connection is set and ready.
4 Color Tubing Connection
Figure A-7
Blue Cap
Figure A-8
Set Up Storage tank and Tank Shut-off Valve
installation
Yellow RO Tubing Connection:
1)Remove the Blue Collar Clip, pull the Yellow Protective Cap out of the L-Shaped quick
connector.
2)Insert the supplied Yellow RO Tubing into the L-Shaped quick connector, install the Blue Collar
Clip back on.
3)Connect the other side of the Yellow RO Tubing into the RO Faucet`s Connector, as shown in
System Diagram.
1)Remove the 3M sticker on the bottom of the protector, position the protector and the filtration
system on the same ground level.
2)Use the Tubing Cutter to trim the Blue Tubing at its best fitting length.
3)Insert the trimmed first-half Blue Tubing, that is partially connected to the RO Shut-off Valve,
into the Anti-Leak Protector`s Red-Colored inlet that marked with “IN”, as shown in System
Diagram.
4)Connect the second-half Blue Tubing into the Gray colored outlet that marked with “OUT”, as
shown in System Diagram.
5)Pull out the Blue Collar Clip, remove the Blue Protective Cap from the system's water inlet, and
Insert the Blue Tubing to connect the system.
*While installing, please make sure that the Anti-Leak Protector is placed on the flat ground surface.
*The Anti-Leak Protector is one-time use only. If there is water leak detected, the Anti-Leak Protector shuts off the
water supply to prevent further leaking.
Anti-Leak Protector Installation
Whichever comes available
Old Design New Design
06 07