Installation Guide

Installing Your Water 1000 Pro Series
Installing Your Water 1000 Pro Series 2-26
Flushing Your Filters
Certain types of lters require ushing prior to use. This is important for both the lters
lifespan, and the long term lifespan of your Drinkpod 1000 Pro Series. Additionally,
replacements for these types of lters should be ushed each time one is replaced,
prior to installing. For your 1000 Pro Series, the lter that requires ushing is the
ULTRA+3 Hybrid Scrub .
This section will require
A
1/4 in. White PP Tubing,
G
Filter Flushing Attachment,
the lters listed above, scissors, and a container to ush water into (if your sink isn’t within
reach of your water line).
1. Begin by cutting a 3 ft. to 5 ft. section of 1/4 in. White PP Tubing. Make sure to
cut the tubing at a 90 degree (perpendicular) angle.
Diagram 2.5.1 Cut Tubing Perpendicularly
2. Next, insert one end to the labeled IN port on
G
Filter Flushing Attachment. Be
sure to forcefully push tubing all the way into the QC input until it won’t insert any further.
A