Installation Guide

Installing Your Water 1000 Pro Series
Installing Your Water 1000 Pro Series 2-46
Installing Filters
Please note, only the INTERNAL lter (ULTRA+3 ) is required for the appliance to
function. However, this special edition comes with an additional EXTERNAL lter
(Particle) that will, in many cases, extend your primary lters life. We recommend
installing it from the beginning, but can be connected later, as necessary.
Use of the external lter could result in a reduced ow rate, based on your water
pressure, and the distance between your Drinkpod 1000 Pro Series and water
source.
1. Remove the magnetic lter door from the internal lter compartment.
Diagram 2.8.1 - Remove Magnetic Filter Door To Reveal EZ-twist Mount In Water 1000 Pro Series
2. Grab the ULTRA+3 Hybrid Scrub you ushed earlier (to install in the internal slot).