Installation Guide

Installing Your Water 1000 Pro Series
Installing Your Water 1000 Pro Series 2-51
Diagram 2.8.13 - Connect Expansion Filter Appliance Line To Water 1000 Pro Series Input
14. Connect the end of part
J
Expansion Filter Source Line with the right-angle
tting into the LEFT port of
I
Expansion Filter EZ-Twist Mount (labeled
IN). From now on, we will refer to this as your Source/Input Port, and the
C
1/4 in. Quick Connect Shuto Valve will replace valve we previously attached to
your water source line.
Diagram 2.8.14 - Connect Expansion Filter Source Line To Mount
15. Finally, install the Particle Scrub into
I
Expansion Filter EZ-Twist Mount using the