Installation Guide

Installing Your Water 1000 Pro Series

Installing Your Water 1000 Pro Series 2-53

Enabling Water Flow

This is the second to last stage of installation. In this stage, we will enable water ow at each

shuto valve, one at a time to ensure there are no leaks.

1. If it’s not already open, start by opening your Water Source Valve (the valve on your

existing water source we rst shut o).

2. If you’re using a Sink Water Source, open the valve on

3/8 in. Sink Adapter Valve (if you haven’t already opened it). Conrm there are no

leaks.

Diagram 2.8.2 - Open Sink Adapter Valve

3. Ensure nothing is leaking between the last applicable valve above, and the shuto valve

connected to your Source Line.

4. Now open the valve on the Quick Connect Shuto Valve connected to your Source Line

and Source Input Port on your 1000 Pro Series, as shown below.