Installation Guide

Installing Your Water 1000 Pro Series
Installing Your Water 1000 Pro Series 2-54
Diagram 2.8.4 - Open Shuto Valve
5. You should hear water running and lling the 1000 Pro Series’s tanks. Check for leaks, and
wait until the sound of water running stops.
6. Once the 1000 Pro Series is lled, plug it in, but do not ip on the power switches yet.
7. We need to ush each temperature mode. Start by ushing the Ambient Mode into
your large container for 30 seconds. Press the light blue Ambient Mode Button to begin
dispensing.
8. Now, for the best experience, we recommend ushing the full tank capacity for both the
Hot Mode and Cold Mode. For reference, the Hot Tank capacity is 0.26 gal (1 liter),
and the Cold Tank capacity is 1.1 gal (4.16 liters). For directions on how to ush your
appliance, see the included Use & Care Guide, or the Quick Start Sticker applied to
your Drinkpod 1000 Pro Series’s control panel.
9. If you haven’t connected any accessory appliances to your new
Drinkpod 1000 Pro Series, you are nished!!! You can now proceed to power on your
1000 Pro Series (see Use & Care Guide for instructions).
10. If you have connected accessory appliances, you can now open the
C
1/4 in. Quick Connect Shuto Valve(s) connected to your Accessory Line. Water
should now start owing into your accessory appliances. Check the lines, valve, and