Use and Care Guide

Using Your 1000 Pro Series 9
Using Your 1000 Pro Series
This guide will explain how to use, maintain, and troubleshoot your new 1000 Pro Series.
Be sure to complete all of the applicable instructions in the Installation Guide,
included with your 1000 Pro Series prior to using the appliance.
Powering On/O Your 1000 Pro Series
Be sure to never plug in your 1000 Pro Series, or power on either temperature mode
before you’ve connected a proper water source, and enabled water ow.
1. To power on your 1000 Pro Series, simply plug in
Z
110v Power Cord into a 110 volt
electrical outlet. To power o, unplug the appliance.
2. To power on the cooling system, ip the green
X
Cold Mode Power Switch (on the
left) up, into the on position. To power o, ip back down.
3. To power on the heating system, ip the red
Y
Hot Mode Power Switch (right) up,
into the on position. To power o, ip back down.
Dispensing Water
Dispensing water can be accomplished by pressing 1 - 3 buttons, depending on the situation.
What temperature of water is dispensed (temperature modes), and the amount of water
that is dispensed (dispense modes) can be selected by pressing the temperature and
dispense mode buttons. By default, your 1000 Pro Series is set to (and will always return to)
QuickFill Mode / Press-To-Fill Mode, and Cold Temperature Mode, which can simply
be triggered by pressing or holding the
N
Dispense Button.
1. For non-default usage, start by selecting your temperature mode of choice, by
pressing one of the following buttons.
J
Hot Dispense Mode Button - Child Safety Lock function requires dispense
button to be pressed within 5 seconds of selecting hot mode.
K
Ambient Dispense Mode Button
L
Cold Dispense Mode Button - DEFAULT
Next, select your preferred dispense mode by following the relevant instructions
for that specic mode.
Press-To-Fill Mode can be triggered by simply pressing and holding your nger down