Use and Care Guide

Maintaining Your 1000 Pro Series
Maintaining Your 1000 Pro Series 14
to aim the water outlet on the attachment into your container.
8. Now, disconnect the
G
Filter Flushing Setup from the
C
1/4 in. Quick Connect Shuto Valve and reattach it to the
BB
Source Input Port
9. Next, if replacing the internal lter, open the
R
Internal Filter Door by inserting your
nger into the opening at the top, and pulling lightly down and outward.
10. Lay a towel down across the base of the internal lter cavity, to catch any water that
drips down, and prevent triggering
CC
Leak Detection Sensor.
11. Replace the applicable lter(s) in the location(s). Filters can be removed by
twisting counter clockwise. To insert new lters, press lter upward into the
S
Internal Filter EZ-twist Mount and
EE
External Filter EZ-twist Mount (if in use)
while twisting clockwise.
F1
ULTRA+3 Hybrid Scrub (DEFAULT - Internal Filter Slot)
F2
Particle Scrub (DEFAULT/OPTIONAL - External Filter Slot)
F5
Polishing Scrub (Alternative - Internal Filter Slot)
F3
Chemical Scrub (Alternative - External Filter Slot)
12. Reattach the
R
Internal Filter Door, and discard the old lter(s).
13. Open the
C
1/4 in. Quick Connect Shuto Valve, to enable water ow.
14. Place your container below the
O
Water Dispenser Nozzle one last time, then press
the
K
Ambient Dispense Mode Button, quickly followed by pressing and holding
the
N
Dispense Button until water ow is constant, to re-pressurize the system. Once
water is steadily dispensing, you can stop.
15. Plug
Z
110v Power Cord back into the electrical outlet.
16. Finally, press and hold the
C
ECO Mode/Filter Rest Button for 5 seconds to reset
the timer and
I
Pod Filter(s) Status Light. You’re nished!