Use and Care Guide

Maintaining Your 1000 Pro Series 15

Maintaining Your 1000 Pro Series

Storing & Relocating Your 1000 Pro Series

At some point, you may need to store or relocate your 1000 Pro Series. Should one of these

situations be the case for you, below are a few simple steps to prevent any damage from

occurring.

1. First, if the cooling and/or heating systems are powered on, ip

Hot Mode Power Switch and

Cold Mode Power Switch into the down position

to power o. This should always be done prior to shutting o water supply.

2. Shuto water ow to your appliance by turning the blue handle on the

1/4 in. Quick Connect Shuto Valve (see Installation Guide) connected to your

1000 Pro Series’s

Source Input Port located at the back of the appliance.

3. Grab a container (preferably with high sides) , like a bucket or pitcher, and place it on

the oor in front of your 1000 Pro Series.

4. Rotate your 1000 Pro Series counter-clockwise 90 degrees and slide forward towards

the edge of your counter-top (or whatever surface it is resting on) until roughly 30%

of your 1000 Pro Series’s left side is extending over the edge. This will expose

Appliance Drain Port. Be sure to keep it braced with your body so it does not fall!

5. Ensure your container is directly below the

Appliance Drain Port.