Use and Care Manual

Using Your DRINKPOD
Using Your DRINKPOD 1-8
This guide will explain how to use, maintain, and troubleshoot your new DRINKPOD 5.
Be sure to complete all of the applicable instructions in the Installation Guide,
included with your DRINKPOD prior to using the appliance.
Powering On/O Your Drinkpod
Be sure to never plug in your Drinkpod, or power on either temperature mode
before you’ve connected a proper water source, and enabled water ow.
1. To power on your DRINKPOD 5, simply plug in
J
110v Power Cord into a 110 volt
electrical outlet. To power o, unplug the appliance.
2. To power on the cooling system, ip the green
T
Heating System Power Switch
(on the left) up, into the on position. To power o, ip back down.
3. To power on the heating system, ip the red
U
Cooling System Power Switch
(right) up, into the on position. To power o, ip back down.
Dispensing Water
When rst using your Drinkpod (or any time after it has been drained), it is rst
necessary to allow time for the inner tanks to completely ll.
1. To dispense cold water, simply press the
C
Cold Dispense Button.
2. To dispense hot water, rst press in (towards the back of the appliance) and hold the red
B
Child Safety Lock, then, press down
A
Hot Dispense Button.
Replacing Your DRINKPOD 5’s Filters
Your DRINKPOD 5 lters should be changed every 1000 gallons (approximately 6 - 12
months for the typical user).If you wish to change them individually to obtain the maximum
usage of each, you may reference the table below for their individual lifespans.
Filter Name & Model # Estimated Gallons Estimated Months
Chemical Scrub DPSCRUB02EZ 1900 GAL 18 - 24 mo.
ULTRA Scrub DSCRUB04EZ 1425 GAL 12 - 18 mo.
Polishing Scrub DSCRUB10EZ 950 GAL 6 - 12 mo.