Use and Care Manual

Using Your DRINKPOD 1-9

Using Your DRINKPOD

For this step, you will need a towel and a container to catch water.

1. Shuto water ow to your appliance by turning the blue handle on the

1/4 in. Quick Connect Shuto Valve (see Installation Guide) connected to your

DRINKPOD’s

Water Input Line located at the back of the appliance.

2. Next, place your container underneath the dispensers, and press

Cold Dispense Button and

Child Safety Lock +

Hot Dispense Button until

water stops owing to de-pressurize the system.

3. Empty your container of water.

4. Place a towel below the lter hub to catch any water that drips out.

5. Twist each of the current lters roughly 45 degrees counterclockwise, replacing each

with your new lter as you go (to ensure they are replaced in the correct order).

6. Open the

1/4 in. Quick Connect Shuto Valve, to enable water ow.

7. Place your container below the dispensers again, and proceed to dispense water from

each of the dispense modes ushing the full capacity of each tank, as shown below.

Mode/Tank Capacity To Flush

Cold (+

Reserve)

1.1 gal (4.16 liters) + 1.06 GAL (4 L) +1 GAL (3.79 L)

≈ 3 GAL (11 L)

Hot 0.26 gal (1 liter) +1 GAL (3.79 L)

≈ 2.5 GAL (9 L)

8. Your nished!