Use and Care Manual
Maintaining Your DRINKPOD
Maintaining Your DRINKPOD 1-10
Storing & Relocating Your DRINKPOD 5
At some point, you may need to store or relocate your DRINKPOD 5. Should one of these
situations be the case for you, below are a few simple steps to prevent any damage from
occurring.
1. First, if the cooling and/or heating systems are powered on, ip
U
Cooling System Power Switch and
T
Heating System Power Switch into the
down position to power o. This should always be done prior to shutting o water
supply.
2. Shuto the waterow to your DRINKPOD at the water source (i.e. your icemaker
hookup or under your sink
3. Shuto water ow to your appliance by turning the blue handle on the
C
1/4 in. Quick Connect Shuto Valve (see Installation Guide) connected to your
DRINKPOD’s
M
Water Input Line located at the back of the appliance.
4. Place a cup below dispensers and dispense water from both hot and cold modes until
water stops coming out.
5. Grab a container with high sides, like a bucket or pitcher, and place it on the oor in
front of your DRINKPOD 5.
6. Rotate your DRINKPOD counter-clockwise 180 degrees and slide towards the edge of
your counter-top until the
V
Appliance Drain Port is extended over the edge.
V