Use and Care Manual

Maintaining Your DRINKPOD
Maintaining Your DRINKPOD 1-12
15. Disconnect the tubing running between our DRINKPOD’s
M
Water Input Line and
the
C
1/4 in. Quick Connect Shuto Valve you just shuto, and place end of the
tubing into a container to catch any water that drains back.
16. Now remove the lter(s). If the lter(s) will not be used for more than a few days,
we highly recommend discarding them, and replacing them with new ones, to
avoid any bacteria or mold growth issues. Storing them in your refrigerator may
extend this time, but results will vary.
17. Finally, unplug
J
Power Cable from the electrical outlet. You’re nished!
Leaving Your DRINKPOD 5 (Vacation)
If you plan to take a trip, and leave your DRINKPOD 5 for more than a few days, We highly
recommend following the steps below prior to leaving. This will help prevent any damage
from occurring, the rare possibility of leaks, and returning to poor tasting water. If your trip
is more than two weeks, we recommend using these steps instead, “Storing & Relocating”
on page 1-10.
1. First, if the cooling and/or heating systems are powered on, ip
U
Cooling System Power Switch and
T
Heating System Power Switch into the
down position to power o. This should always be done prior to shutting o water
supply.
2. Shuto water ow to your appliance by turning the blue handle on the
C
1/4 in. Quick Connect Shuto Valve (see Installation Guide) connected to your
DRINKPOD’s
M
Water Input Line located at the back of the appliance.
3. Next, unplug
J
Power Cable from the electrical outlet.
4. When you return, after reconnecting tubing, reinstalling lters, and re-enabling
water ow (in that order), we recommend ushing 1 gallon of water from each
temperature mode prior to use. Have a great trip!