Installation Guide
Installing Your Drinkpod
Installing Your Drinkpod 2-19
Diagram 2.6.3-A - Screw Compression To Quick Connect Adapter Onto Port or Hose
acc.
1x
For 1 Accessory Appliance Congurations, you will need to run a section of
A
1/4 in. White PP Tubing from your Accessory Appliance, directly to where
you plan to locate your DRINKPOD 6 (unless the appliance already has an integrated
Quick Connect Tubing hose you plan to use instead). Finish by connecting the
other
C
1/4 in. Quick Connect Shuto Valve to the end of the tubing or
hose that will connect to your DRINKPOD. It should look like this:
acc.
1x
HOSE/PORT
>
ADAPTER (if necessary)
>
TUBING
(if necessary)
>
SHUTOFF VALVE (where DRINKPOD 6 will be located)
Once you’ve completed this, jump ahead to “Connecting Your DRINKPOD 6” on
page 2-25.
If your Accessory Appliance’s port or hose is Female Compression, use
D
1/4 in. Brass Compression Union to adapt the port/hose to the
1/4 in. White PP Tubing line (referenced above). Instructions for this are including in
the following step and “Diagram 2.6.4-B” on page 2-21.
Extending
4. If your appliance has a port (rather than a hose), or a hose that will not reach suciently
far, follow the relevant directions below.