Instructions / Assembly

Using Your DRINKPOD 3-1
Using Your DRINKPOD
This guide will explain how to use, maintain, and troubleshoot your new DRINKPOD 6.
Be sure to complete all of the applicable instructions in the Installation Guide,
included with your DRINKPOD prior to using the appliance.
Powering On/O Your Drinkpod
Be sure to never plug in your Drinkpod, or power on either temperature mode
before you’ve connected a proper water source, and enabled water ow.
1. To power on your DRINKPOD 6, simply plug in
H
110 Volt Power Cable into a 110
volt electrical outlet. To power o, unplug the appliance.
2. To power on the cooling system, ip the green
T
Heating System Power Switch
(on the left) up, into the on position. To power o, ip back down.
3. To power on the heating system, ip the red
U
Cooling System Power Switch
(right) up, into the on position. To power o, ip back down.
Dispensing Water
When rst using your Drinkpod (or any time after it has been drained), it is rst
necessary to allow time for the inner tanks to completely ll.
1. To dispense cold water, simply press in the
C
Cold Dispense Paddle with the cup or
container you wish to ll.
2. To dispense hot water, rst press in and hold the red
B
Child Safety Lock, then, press the
A
Hot Dispense Paddle in with the cup or container you wish to ll against.