Instructions / Assembly

Maintaining Your DRINKPOD

Maintaining Your DRINKPOD 4-2

Mode/Tank Capacity To Flush

Cold (+

Reserve)

0.79 GAL (3 L) + 1.06 GAL (4 L) +1 GAL (3.79 L)

≈ 3 GAL (11 L)

Hot 1.32 GAL (5 L) +1 GAL (3.79 L)

≈ 3.5 GAL (9 L)

9. Your nished!

Storing & Relocating Your DRINKPOD 6

At some point, you may need to store or relocate your DRINKPOD 6. Should one of these

situations be the case for you, below are a few simple steps to prevent any damage from

occurring.

1. First, if the cooling and/or heating systems are powered on, ip

Cooling System Power Switch and

Heating System Power Switch into the

down position to power o. This should always be done prior to shutting o water

supply.

2. Shuto the waterow to your DRINKPOD at the water source (i.e. your icemaker

hookup or under your sink

3. Shuto water ow to your appliance by turning the blue handle on the

1/4 in. Quick Connect Shuto Valve (see Installation Guide) connected to your

DRINKPOD’s

Water Input Port located at the back of the appliance.

4. Place a cup below dispensers and dispense water from both hot and cold modes until

water stops coming out.

5. Grab a container with high sides, like a bucket or pitcher, and place it on the oor in

front of your DRINKPOD 6.

6. Pull your DRINKPOD counter-clockwise away from the wall, and rotate it as necessary

to allow for room for your container beneath the

Appliance Drain Port is

extended over the edge.