Instructions / Assembly
Maintaining Your DRINKPOD
Maintaining Your DRINKPOD 4-4
10. Reattach the
DP1
Drain Ca.
11. Next, if applicable, shuto the
C
1/4 in. Quick Connect Shuto Valve connected
between your DRINKPOD’s
L
Ice & Coee Connect Port and any accessory
appliances (i.e. coee maker) and disconnect the tubing from the port. Placing a towel
underneath your ports will help save time cleaning up drippage.
12. Make any necessary adjustments to your accessory appliances in lieu of them no longer
receiving water (i.e. powering them o in necessary).
13. Disconnect the tubing running between our DRINKPOD’s
M
Water Input Port and
the
C
1/4 in. Quick Connect Shuto Valve you just shuto, and place end of the
tubing into a container to catch any water that drains back.
14. Now remove the lter(s). If the lter(s) will not be used for more than a few days,
we highly recommend discarding them, and replacing them with new ones, to
avoid any bacteria or mold growth issues. Storing them in your refrigerator may
extend this time, but results will vary.
15. Finally, unplug
H
110 Volt Power Cable from the electrical outlet. You’re nished!
Leaving Your DRINKPOD 6 (Vacation)
If you plan to take a trip, and leave your DRINKPOD 6 for more than a few days, We highly
recommend following the steps below prior to leaving. This will help prevent any damage
from occurring, the rare possibility of leaks, and returning to poor tasting water. If your trip
is more than two weeks, we recommend using these steps instead, “Storing & Relocating”
on page 3-4.
1. First, if the cooling and/or heating systems are powered on, ip
U
Cooling System Power Switch and
T
Heating System Power Switch into the
down position to power o. This should always be done prior to shutting o water
supply.
2. Shuto water ow to your appliance by turning the blue handle on the
C
1/4 in. Quick Connect Shuto Valve (see Installation Guide) connected to your
DRINKPOD’s
M
Water Input Port located at the back of the appliance.