Installation Guide

Installing Your Drinkpod
Installing Your Drinkpod 2-27
6. If you’ve connected accessory appliances, use the same method from Step #4 to
remove Acc. Output Port Plug from Accessory Output Port on the back of your
DRINKPOD 6. If you don’t have any accessory appliances, proceed to “Installing
Filters” on page 2-28.
7. Next, connect the open end of the section of
A
1/4 in. White PP Tubing connected
to your Accessory Line to the Accessory Output Port on the back of your DRINKPOD,
the same way you did with the Source Line in Step #5.
8. Ensure both
C
1/4 in. Quick Connect Shuto Valve(s) are closed as shown below,
then proceed to “Installing Filters” on page 2-28.
Diagram 2.7.8 - Ensure Valve Is Closed