Installation Guide

Installing Your Drinkpod

Installing Your Drinkpod 2-28

Installing Filters

Please note, ALL 3 lter slots must ALWAYS be lled prior to use. If one or more

lter slots are empty, the appliance will not dispense, and leak water continuously

until the leak sensor is triggered, or water ow is shut o.

1. Remove the lower front panel by gripping its side edges and pulling it directly

backwards. Inside you will see 3 mounting brackets.

Diagram 2.8.1 - Open Cabinet To Reveal Filter Mounting Brackets In 2-28

2. Now, grab the lters (

Chemical ,

ULTRA, and

Polishing)from the

packaging. Remove the bags and top caps. Filters should be installed in the order shown.

Diagram 2.8.2 - Filter Installation Order

F1 F2 F3