Installation Guide

Installing Your Drinkpod

Installing Your Drinkpod 2-33

Diagram 2.8.4 - Open Shuto Valve

5. You should hear water running and lling the DRINKPOD’s tanks. Check for leaks, and

wait until the sound of water running stops.

6. Once the DRINKPOD is lled, plug it in, but do not ip on the power switches yet.

7. We need to ush each temperature mode. Start by ushing the Ambient Mode into

your large container for 30 seconds. Press the light blue Ambient Mode Button to begin

dispensing.

8. Now, for the best experience, we recommend ushing the full tank capacity for both the

Hot Mode and Cold Mode. For reference, the Hot Tank capacity is 1.32 GAL (5 L),

and the Cold Tank capacity is 0.79 GAL (3 L). Flushing these modes can be

accomplished by sliding the red Hot Mode Safety Switch to the left and then holding it

there while pressing the Hot Mode Button to ush hot water.

9. Next, press the darker blue Cold Mode Button (on the right) to ush cold water..

10. If you haven’t connected any accessory appliances to your new DRINKPOD 6, you

are nished!!! You can now proceed to power on your DRINKPOD (see Use & Care

Guide for instructions).

11. If you have connected accessory appliances, you can now open the

1/4 in. Quick Connect Shuto Valve(s) connected to your Accessory Line. Water

should now start owing into your accessory appliances. Check the lines, valve, and