Installation Guide

Installing Your Drinkpod
Installing Your Drinkpod 2-34
appliances for leaks.
Diagram 2.8.11 - Open Shuto Valve On Accessory Line
12. Once you here the water stop owing, you can plug your accessory appliances back in
and power them on. If possible, ush water through each for 1 minute.
Flushing Your Filters
This is the nal step. Certain types of lters require ushing prior to use. This ensures
any loose carbon particles in your lter media are discharged prior to drinking.
ALWAYS ush newly installed lters, prior to drinking. For your kit, the two specic lters
that need ushed are
F1
Chemical Scrub and
F3
Polishing Scrub.
1. Place a container of water under one of the dispensers.
2. Proceed to dispense the full contents of each tank plus one gallon (to allow for the rest
of the internal water system). See the total volume for each below.
Mode/Tank Capacity To Flush
Cold (+ Reserve) 0.79 GAL (3 L) + 1.06 GAL (4 L) +1 GAL (3.79 L) ≈ 3 GAL (11 L)
Hot 1.32 GAL (5 L) +1 GAL (3.79 L) ≈ 2.5 GAL (9 L)
Congratulations! You have reached the end. You may now proceed to power on
your DRINKPOD (see Use & Care Guide for instructions).