Low air loss/Alternating pressure mattress Instruction Manual Drive Medical Design & Manufacturing 99 Seaview Boulevard Port Washington, NY 11050 Toll Free: 877-224-0946 Local: 516-998-4600 www.drivemedical.com REV2.12.17.13 746002-5150 V1.0 15 PLEASE READ ALL INSTRUCTIONS BEFORE USE.
CONTENTS IMPORTANT SAFEGUARDS...................................................... 2 1. INTRODUCTION .................................................................... 3 a/ The ISM (industrial, scientific and medical) bands between 150 kHz and 80 MHz are 6,765 MHz to 6,795 MHz;13,553 MHz to 13,567 MHz; 26,957 MHz to 27,283 MHz; and 40,66 MHz to 40,70 MHz. b/ The compliance levels in the ISM frequency bands between 150 kHz and 80 MHz and in the frequency range 80 MHz to 2.
Guidance and Manufacturer’s Declaration - Electromagnetic Immunity: IMPORTANT SAFEGUARDS This device is intended for use in the electromagnetic environment specified below. The user of this device should make sure it is used in such an environment.
1. INTRODUCTION APPENDIX A: EMC INFORMATION This manual should be used for initial set up of the system and for reference purposes. Guidance and Manufacturer’s Declaration- Electromagnetic Emissions: 1.1 GENERAL INFORMATION This device is intended for use in the electromagnetic environment specified below. The user of this device should make sure it is used in such an environment.
SAVE THESE INSTRUCTIONS GROUNDING INSTRUCTIONS 2. PRODUCT DESCRIPTION This product should be grounded. In the event of an electrical short circuit grounding reduces the risk of electric shock by providing an escape wire for the electric current. This product is equipped with a cord 2.1 PUMP AND MATTRESS SYSTEM having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly 1. CPR Tags installed and grounded. 2. Pump unit 3.
3. INSTALLATION Unpack the box and check the package contents for completeness. Package Content List n Mattress unit x 1 (may not be included if only pump unit is purchased) 8. TECHNICAL DESCRIPTION Specifications: Item Specification n Pump Unit x 1 Power Supply (Note: See n User Manual x 1 rating label on the product) Inspect equipment for damage which may have occurred during shipment. If there is damage, please contact your dealer immediately. Fuse Rating Cycle time Dimension (L x W x H) 3.
6. MATTRESS STORAGE 4. Plug the power cord into a electrical outlet with the appropriate voltage. NOTE: The pump unit must be suitable for the 1. Lay the mattress on a flat surface, upside-down. local power voltage. 2. Roll-up the mattress starting from the head until you reach the foot of the mattress. NOTE: S’assure que la pompe est compatible 3. Use the straps at the end of the mattress and stretch them around the mattress to prevent it from au voltage local ou disponible. unraveling.
NOTE: If the pressure level is consistently low, check for any leakage (tubes or air hoses). If 4. OPERATIONS necessary, replace any damaged tubes or hoses or contact your local qualified dealer for repair. NOTE: Always read the operating instructions before use. 4. Alternate / Static Switch 4.1 PANEL OPERATIONS The ALTERNATE/STATIC switch selects between Alternate Pressure mode and Static Pressure 1 2 mode.