Wallaby Wheelchair Item #s WB 1200, WB 1400 Accessories WB 8021 - Headrest Extension WB 8030 - Five-Point Harness www.drivemedical.
Introduction Hand Grip Back Upholstery Armrest Pad Armrest Rear Wheel Side Panel Seatbelt Seat Upholstery Cap Hub Rear Wheel Rigging Brakes Caster Fork Caster Front Footplate Congratulations on your purchase of a Drive wheelchair. Drive wheelchairs are a product of quality engineering and are manufactured to meet our own highly rigid specifications and will surpass all your expectations. Please read this manual carefully to insure safe usage and understanding of maintenance instructions.
Cautions STREET USE - In most states, it is illegal for use on public roads. Do not operate this wheelchair on roadways, streets or any surfaces with vehicular traffic. MOTOR VEHICLE SAFETY - Wheelchair conforms to the requirements of ANSI/RESNA WC/VoL.1-Section 19. The wheelchair has been dynamically tested in a forward facing mode and it must be forward facing during transport. Use with approved vehicle-installed restraining system that includes both pelvic and shoulder belts.
Cautions (con’t) TRANSFER - Work with a qualified professional before you transfer on your own as it is dangerous. Engage rear wheel locks before you transfer and the chair should be on a smooth, stable and level area. Move your chair as close as you can to the seat you are transferring to, rotate the front casters until they are as far forward as possible, make sure armrests are out of the way and remove or swing footrests out of the way if you can. Do not stand or apply weight to footrest.
Use and Adjustments OPENING THE CHAIR - To open the chair, tilt it to one side and push down on seat rail until it is fully opened. CLOSING/FOLDING THE CHAIR - To close the chair, fold foot plates, grasp seat with both hands at front and back edge and lift. Or, you can tilt chair to one side and lift up on seat rail. WHEEL LOCKS - Proper angle position of wheel lock is at least 1/8” when locked. Loosen or tighten nut on the carriage bolt.
Wheelchair Securement Points Securement Points
Accessories Headrest Extension - Item # WB 8021 1. To install WB 8021 (headrest extension) remove end caps (B). (Fig 4) 2. Adjust width of headrest extension by removing headrest cover by opening Velcro™ flap. (Fig 5) 3. Separate the two sections and insert them individually into sockets on the back of the chair. 4. Reattach the flaps. 5 . Replace headrest cover. Fig 5 Fig 4 B Five-Point Harness - Item # WB 8030 1.
Lifetime Limited Warranty Your Drive Medical product is warranted to be free of defects in materials and workmanship for the lifetime of the original consumer purchaser. This device was built to exacting standards and carefully inspected prior to shipment. This Lifetime Limited Warranty is an expression of our confidence in the materials and workmanship of our products and our assurance to the consumer of years of dependable service.