User Manual

Step 2  Cover with a cotton sheet to avoid direct skin contact and reduce friction.
Step 3  Hang the pump unit on the foot end of the bed frame and make sure it is stable.
Step 4  Connect the inflation tubes from the mattress to the pump’s inflating nozzles.
Make sure they are properly attached.
NOTE:
Make sure the air hoses are not kinked or tucked under the mattress.
Also check to ensure the CPR valve is properly attached.
Step 5  Plug the power cord into an electrical outlet with grounded AC power.
This product should be grounded. The power cord has a grounding wire with a grounding
pin. This three-wire plug must be plugged properly into an outlet and grounded as shown
in the figures in the Grounding Instructions section.
NOTE:
Before inserting the plug into the outlet, make sure the voltage is compatible.
Also make sure this product is well grounded.
Step 6  Turn on the power by pressing the power switch at the right side of the unit.
Proceed to the Operation section.
GROUNDING INSTRUCTIONS
This product is for use on a nominal 120 V circuit and should be grounded. In the event of an
electrical short circuit, grounding reduces the risk of electric shock by providing an escape
wire for the electric current. This product is equipped with a cord that contains a grounding
wire with a grounding plug.
DANGER – Improper use of the grounding plug can result in a risk of electric shock.
If repair or replacement of the cord or plug is necessary, do not connect the grounding to
either flat blade terminal. The wire with insulation having an outer surface that is green with or
without yellow stripe is the grounding wire.
Check with a qualified electrician or serviceman if the grounding instructions are not
completely understood, or if in doubt as to whether the product is properly grounded.
This product has a grounding plug that looks like the plug illustrated in figure A below. A
temporary adapter, which looks like the adapter illustrated in figure B and C, may be used to
connect this plug to a 2-pole receptacle as shown in figure B if a properly grounded outlet is
not available. The temporary adapter should be used only with a properly grounded outlet. It
can be installed by a qualified electrician. The green colored rigid ear, lug, tab or the like
extending from the adapter must be connected to a permanent ground such as properly
grounded outlet box cover. Whenever the adapter is used, it must be held in place by the
screw.
If it is necessary to use an extension cord, use only a 3-wire extension cord that has a
three-blade grounding plug and a 3-slot receptacle that will accept the plug on the product.
Replace or repair if damaged.