Datasheet

Linear actuator DSZY1

Electric linear actuators are used in many different

applications.

DSZY1 Standard is equipped with a rugged acme screw

with high static force. It is a small, compact and lightweight

dc-linear drive.

Internal diodes allow the easy change of direction by

reversing the power-supply. All DSZY1-actuators have two

end-switches integrated ( not possible to adjust ).

An overload-protection can be made by using a current

control.

Model code

DSZY1

200

IP65

typ

voltage

12V

24V

gear reduction

ACME

stroke

50mm

100mm

150mm

200mm

250mm

300mm

protection type

Diagram

load – current - diagram

load – speed - diagram

load nominal

load max

Additional technical data

 push/pull force up to 1200N

 static force 2000N

 Operating temperature -26C°- 65C°

 Duty cycle 25%

 Zinc alloy housing

 Aluminium outer tube and stroke rod

 Voltage 12 or 24 VDC

 Options: potentiometer and

hall sensors

 Protection type IP65

PAGE 1
Linear actuator DSZY1 Electric linear actuators are used in many different applications. DSZY1 Standard is equipped with a rugged acme screw with high static force. It is a small, compact and lightweight dc-linear drive. Internal diodes allow the easy change of direction by reversing the power-supply. All DSZY1-actuators have two end-switches integrated ( not possible to adjust ). An overload-protection can be made by using a current control.
PAGE 2
Dimension Length Linear actuator Mass in mm Stroke ± 3mm 50 100 150 200 250 300 A 158 209 260 311 362 413 B 208 309 410 511 612 713 DSZY1 - type standard Mounting instruction Please make sure, that load is not bigger than shown in the diagram speed/load. If overload is possible in the application, please use a separate current control to switch off at too high current ( = too high load ). Nominal current, depending on ratio, is shown in the diagram current / load.
PAGE 3
Installation manual DSZY1 Make sure the actuator ist not connected electrically when installed. Make sure you use the correct DC voltage. Actuator force must not be over loaded. Please refer to the model number and it’s force specification. To avoid over load disconnect the actuator if the current exceed it’s maximum rating. The load should be centered on the operating direction. Side load is NOT good for the actuator. In case the actuator rod is exposed to side load the service life time will be reduced.