Datasheet

Dimension

Linear actuator

Length

Mass in mm

Stroke ± 3mm

100

150

200

250

300

DSZY1 - type standard

158

209

260

311

362

413

208

309

410

511

612

713

Mounting instruction

Please make sure, that load is not bigger than shown in the diagram speed/load. If overload is possible in the application,

please use a separate current control to switch off at too high current ( = too high load ). Nominal current, depending on

ratio, is shown in the diagram current / load.

Please use the right voltage supply as it is shown on the actuator. For extending the piston rod connect the red cable with

plus and the black cable with minus. Movement is stopped automatically at the end of the stroke. For moving back,

reverse the polarity (change plus and minus). Endswitches are not adjustable by themselves.

Load should be centered in moving direction, shear forces should be avoid because of shortening the lifetime. Big shear

forces can destroy the actuator! Be carefull.

Drive-System Europe Ltd.

www.drive-system.com

sales@drive-system.com