Datasheet

© Copyright by Drive-System Europe Ltd. Stand: 24.08.2011
Installation manual DSZY1
Make sure the actuator ist not connected electrically when installed.
Make sure you use the correct DC voltage.
Actuator force must not be over loaded. Please refer to the model
number and it’s force specification.
To avoid over load disconnect the actuator if the current exceed
it’s maximum rating.
The load should be centered on the operating direction. Side load
is NOT good for the actuator.
In case the actuator rod is exposed to side load the service life
time will be reduced.
load
–
current
-
diagram
load
–
speed
-
diagram
load nominal
load max
The actuator will extend when the red wire connects to plus
and the black wire connects to negative. In order to retract
or extract again the supply voltage polarity must be
reverted.
The actuator have integrated limit switches that will stop the
rod when it reach it’s end position of extraction or
retraction.
Drive-System Europe Ltd.
www.drive-system.com
[e-mail]