Patient Lift Scale Indicator Owner’s Manual Item # 13046
INTRODUCTION TABLE OF CONTENTS Thank you for purchasing the Model PL600DM Patient Lift Scale Indicator. It has been manufactured with quality and reliability. This instrument has been tested before leaving our factory to insure accuracy and dependability for years to come. Introduction . . . . . . . . . . . . . . . . . . . . . . . . . Specifications . . . . . . . . . . . . . . . . . . . . . . . Installation . . . . . . . . . . . . . . . . . . . . . . . . . Battery Replacement . . . . . . . . . . . . . .
This page intentionally left blank.
INSTALLATION The PL600DM Patient Lift Scale Indicator is a completely self-contained, battery-powered instrument that is used to determine the weight of a person suspended from a portable patient lift mechanism. The PL600DM consists of a weight indicator with an integral tension load cell and with its small size and simple, easy operation; it can be used where standard indicators are too large and cumbersome.
KEYPAD FUNCTIONS The PL600DM Patient Lift Scale Indicator has a membrane keypad containing three (3) keys. The keypad is shown in Figure No. 3. The following describes the use of each key: The membrane keyboard is not to be operated with pointed objects (pencils, pens, fingernail, etc.). Damage to the keypad from this practice will NOT be covered under warranty. ON ZERO Figure No. 3 Pressing this key will apply power to the instrument and turn on the indicator display.
AUTOMATIC SHUT-OFF FEATURE . The PL600DM is equipped with an automatic shut-off feature that helps prolong battery life by turning the indicator off after a preset amount of time after a stable weight reading has been reached. To turn the indicator back on you must press the ON/ZERO key.
SETUP AND CALIBRATION 1. To begin Setup and Calibration, press the ON/ZERO key to turn the indicator on. When the display is showing U , simultaneously press the ON/ZERO and the UNITS keys. 2. The indicator will display &$/. Press the ON/ZERO key to select 0 = do not calibrate (allows you to setup the indicator without calibrating) or 1 = enter calibration, and then press the UNITS key to save the setting. If you select 0 = do not calibrate, then proceed to step 6.
PARTS IDENTIFICATION 9 8 7 6 5 4 3 10 2 1 ITEM PART NO.
8
9
8551-M963-01 Rev A 04/05 Printed in USA 10
