Product Manual

OPERATION
NOTE: Always read the operating instructions before use.
General
This product is designed to provide maximum comfort to home care patients. Make sure that
you operate this product in a proper way to optimizing its value. Here we provide some general
information you should be aware of.
For products: DO NOT use another pump with different specifications from the Med Aire
series. It is dangerous to use a pump with pressure capacity greater than
120 mmHg. This may result in cell-puncture.
DO NOT change any component by yourself. If there is need for
replacement or repair, always contact your local dealer or service center.
For patients: When the Normal Pressure LED (green) comes on to indicate the pressure
is adjusted to a desired firmness; the patient can then lie on the mattress.
Please cover the mattress with a cotton sheet to avoid direct skin contact
and for the patient’s comfort.
A firm surface will make it easier for the patient to transfer or reposition.
Make use of the static mode function. It can support the patient by keeping
the mattress from bottoming out when the patient is in a sitting position
Hand check: Check to see if a suitable pressure is selected by sliding one hand between
the air mattress and the foam base (or bed frame if there is no foam base) to
feel the patient’s buttock.
Users should be able to feel the space in between, and the acceptable range
is approximately 25 to 40 mm (1” to 1-1/2”). This hand check procedure is
issued by AHCPR.
Please follow instructions below for detailed operating procedure of each type.
14048
Step 1 fTurn on the power. A beep sound will begin the operation.
Step 2 fThese two types will enter static mode initially when the power is turned on.