Product Manual
2
assembly inspection
ELECTRICAL
CONTROL BOX Inspect – 6 months
1. Check power cord for chafing cuts or wear.
2. Make sure all aaching hardware is securely tightened.
3. Check electrical connections for wear or fractures.
PENDANT Inspect – 6 months
1. Check pendant cord for chafing cuts or wear.
2. Check all pendant functions:
• Head raises and lowers properly.
• Foot raises and lowers properly.
• Bed raises and lowers properly (full electric only).
NOTE Follow electrical troubleshooting guide if failures are experienced.
2. Check to make sure each buon and associated function correspond
ACTUATORS Inspect – 6 months
1. Check actuator cords for chafing cuts or wear.
2. Check range of movement on all motors to ensure they do not bind in the FULL
UP or FULL DOWN position.
NOTE Should binding occur, adjust the pull tube of the actuator by turning it
clockwise or counter clockwise (in or out) just enough to allow the motor to shut
off automatically. Failure to do so will damage the head, foot, hi/lo function, and
the internal gears of the actuator.
3. Lubricate acme screws as needed with petroleum jelly.