Setup Manual

Rev. A0-10

3 meter custom USB cable is used to power up and provide USB connectivity to DriverI/DCM

Module. USB custom cable is soldered to DriverI/DCM Device at one end and having R12 (6P6C)

connector at the other end.

Below are specification for the custom 3 meter USB Cable used for DriverI/DCM Module:

 6 wire cable (3 pairs twisted)

 28 AWG Wire

 Impedance (Approx. 90 ohms)

 Cable Outer Dia.(around 3.6mm)

 Aluminum Foil Shielded with Drain Wire

Figure 8: DriverI/DCM Module Custom 3 meter USB Cable Drawing