Setup Manual

Rev. A0-10
19
Figure 17: LTE Module Sim Detection
8. DriverI/DCM Board Operating Steps in FTM Mode (Non-Signalling Mode)
to transmit maximum power:
Step 1: After connecting the device using Tera-Term , Send the following AT commands to set
LTE in FTM mode and transmit maximum RF Output Power:
Command: at!entercnd="A710"
Response: OK
Command: at!daftmact
Response:
290300
OK
Command: at!dasband=43 For Band 2: at!dasband=43
Response: For Band 4: at!dasband=42
43 For Band 12: at!dasband=50
OK For Band 25: at!dasband=61
For Band 26: at!dasband=62
Command: at!dalstxbw=3