Use and Care Manual

Escape 1400 Insert Installation and Operation Manual
7
2 General Information on Escape 1400 Insert (DB03120)
2.1 Appliance performance
(1)
Fuel type
Dry cordwood
Recommended heating area
[*]
500 to 1,600 ft
2
(46 to 149 m
2
)
Firebox volume
1.9 ft
3
(0.054 m
3
)
Maximum burn time
[*]
6 h
Maximum heat output (dry cordwood)
(2)
60,000 BTU/h (17.6 kW)
Overall heat output rate (min. to max.)
(2)(3)
10,800 BTU/h to 34,000 BTU/h
(3.2 kW to 10.0 kW)
Average overall efficiency
(3)
- EPA Cribs /
Douglas Fir
64.0% (HHV
(4)
)
68.0% (LHV
(5)
)
Average overall efficiency
(3)
- Dry cordwood
To come (HHV
(4)
)
To come (LHV
(5)
)
Optimum efficiency
(2)(6)
75.0%
Average particulate emissions rate
(7)
4.3 g/h (EPA / CSA B415.1-10)
Average CO
(8)
To come
[*]
Recommended heating area and maximum burn time may vary subject to location in home, chimney
draft, heat loss factors, climate, fuel type and other variables. The recommended heated area for a given
appliance is defined by the manufacturer as its capacity to maintain a minimum acceptable temperature
in the designated area in case of a power failure.
(1)
Values are as measured per test method, except for the recommended heating area, firebox volume,
maximum burn time and maximum heat output.
(2)
The maximum heat output (dry cordwood) is based on a loading density varying between 15 lb/ft
3
and 20
lb/ft
3
. Other performances are based on a fuel load prescribed by the standard. The specified loading
density varies between 7 lb/ft³ and 12 lb/ft
3
. The moisture content is between 19% and 25%.
(3)
As measured per CSA B415.1-10 stack loss method.
(4)
Higher Heating Value of the fuel.
(5)
Lower Heating Value of the fuel.
(6)
Optimum overall efficiency at a specific burn rate (LHV).
(7)
This appliance is officially tested and certified by an independent agency.
(8)
Carbon monoxide.