Use and Care Manual

Escape 1800-I Insert Installation and Operation Manual
42
Appendix 1: Blower Installation
First, attach the blower assembly
to the insert by aligning and
inserting the hooks on each side
of the blower housing into the
slots located on the left and right
of the blower opening below the
loading door (see DETAIL A).
To assemble the ash lip, open the
door to facilitate the installation.
Center the ash lip with the blower
assembly previously installed and
push it against the firebox. Then
push down the rear fold of the ash
lip so it clips into the two (2)
brackets welded to the firebox
located below the loading door
(see DETAIL A).