Product Manual

7 Electrical connection and calibration of the draw
The furnace is fully assembled at the factory and no electrical connection is required
other than plugging the power cord into an outlet.
7.1 Electrical connections
The following instructions do not replace those of the local code.
Installation and verification of this appliance must be done by a qualified person.
All wiring from the service panel to the heating unit must comply with the electrical code in
force and all local regulations. It is recommended to feed the furnace with its own electrical
circuit of 15 amps at 120 volts with a breaker (see wiring diagram).
WARNING
ONLY USE WIRES SUITABLE FOR 167 °F (75 °C) OR MORE.