Product Manual

PART A – INSTALLATION
INTRODUCTION
This furnace uses the Dual Fire© technology with a two-stage electronic combustion
control. Find peace of mind with a self-regulated combustion that allows easy ignition. Its
automated air supply and self regulated systems synchronize with your thermostat to offer
additional safety, optimize comfort and reduce emissions with minimal maintenance.This
model meets the emissions limits of CSA B415.1-10 Standard and EPA 40CFR Part 60,
subpart QQQQ (2020 limit).
• We recommend that our woodburning hearth products be installed and serviced by
professionals who are certified in the United States by NFI (National Fireplace Institute
®
)
or in Canada by WETT (Wood Energy Technical Training) or in Quebec by APC
(Association des Professionnels du Chauffage).
BEFORE STARTING THE INSTALLATION, READ ALL THE INSTRUCTIONS BELOW
AND MAKE SURE YOU UNDERSTAND THEM. (IF IN DOUBT, CONTACT OUR
CUSTOMER SERVICE AT [e-mail]). FAILURE TO COMPLY
WITH THESE INSTRUCTIONS MAY RESULT IN HAZARD TO YOUR SAFETY AND WILL
AUTOMATICALLY VOID THE WARRANTY.
Inspect the furnace to make sure that nothing has been damaged in the shipping. Pull out
the tools from the flue pipe and/or exchangers and firebox of the furnace.
IMPORTANT NOTE
FOR, INSTALLATION OF A CENTRAL HEATING VENTILATION SYSTEM, IT IS HIGHLY
RECOMMENDED TO CONSULT A HEATING SYSTEM VENTILATION SPECIALIST.
N.B.: STOVE BUILDER INTERNATIONAL INC. IS NOT RESPONSIBLE FOR POOR
APPLIANCE PERFORMANCES, DUE TO IMPROPER INSTALLATION OF EXHAUST
SYSTEM OR DUCTING.