Technical data

Page 5 of 23
Fireplace Assembly
For the assembly of your fireplace, you have received with this manual, all the hardware that you need. See
bellow, the list of what should be included.
 16 screws no 8 x 5/8’’ to fix spacer supports (stand off);
 2 bolts ¼ -20 x ¾’’ to assemble carburetor support on the right side of structure;
 2 spacers of 2’’ for the back of the structure;
 2 spacers of 4’’ for the sides of the structure;
 2 spacer supports of 8’’ for the top of the structure;
 3 wire connecters for the assembly of fan rheostat to 110 Volts inlet wire;
 Carburetor oil pan.
Carburetor
Install the flow-regulating valve on the right side of
the structure. Fasten the valve support plate with
the bolts provided for this purpose. (Figure 5).
Figure 5 : Carburetor assembly
Oil supply pipe
The copper oil supply pipe has
to be hooked up between the
valve’s outlet and the burner’s
inlet. Use an 7/16’’ key.
(Figure 6).
Figure 6 : Hook up of the copper oil supply pipe
Insulating wool
• Remove the chimney trap;
• Install the anchor plate and
the first section of (A type)
factory built chimney of the
brand of your choice;
• The insulating wool has to be
placed on top of the structure.
The top should be completely
covered.
Top spacer supports
The supports have to be
screwed into the drilled
holes (4 each side) on top
of the fireplace structure.
In order to easily locate the
holes under the wool
blanket, use a 2’’ finishing
nail to find holes.
Figure 7 : Insulating wool installation Figure 8 : Top spacer supports installation