Specifications
HT-2000 Installation and Operation Manual     
22 
4.3.6.4 Maximum Burn Cycle Times 
The burn cycle time is the period between loading wood on a coal bed and the 
consumption of that wood back to a coal bed of the same size. The flaming phase of the 
fire lasts for roughly the first half of the burn cycle and the second half is the coal bed 
phase during which there is little or no flame. The length of burn you can expect from your 
stove, including both the flaming and coal bed phases, will be affected by a number of 
things, such as: 
•  firebox size, 
•  the amount of wood loaded, 
•  the species of wood you burn, 
•  the wood moisture content, 
•  the size of the space to be heated, 
•  the climate zone you live in, and 
•  the time of year. 
The table below provides a very general indication of the maximum burn cycle times you 
are likely to experience, based on firebox volume. 
FIREBOX VOLUME
MAXIMUM
BURN TIME
<1.5 cubic feet  3 to 5 hours 
1.5 c.f. to 2.0 c.f  5 to 6 hours 
2.0 c.f. to 2.5 c.f.  6 to 8 hours 
2.5 c.f. to 3.0 c.f.  8 to 9 hours 
>3.0 c.f.  9 to 10 hours 
Long burn times are not necessarily an indication of efficient stove operation. When you 
are home during the day and able to tend the fire, it is preferable to build a smaller fire that 
might provide three or four hours of heating than to fully load the firebox for a much longer 
burn. Shorter burn cycles make it easier to match the heat output of the stove to the heat 
demand of the space. 
4.3.6.5 North-South Fires Versus East-West Fires 
In fireboxes that are roughly square, wood can be loaded so that looking through the glass 
door you see the ends of the logs (north-south) or the sides of the logs (east-west). 
East-west loads that are built compactly break down slowly when heated, but the amount 
of wood you can load is limited because if you put in too many pieces, one may fall against 
the glass. East-west loads are excellent for long, low output fires for relatively mild 
weather. 
North-south loads break down more quickly, but much more wood can be loaded at a time. 
This makes north-south loading good for high output, long lasting fires for cold weather. 










