User Manual

ManualsBrandsDromida ManualsToysDIDC1150

REQUIRED TOOLS

The following items are needed to install your Speed Kit.

✔ Phillips head screw driver

✔ 3/16" nut driver

✔ 1.5mm hex wrench

✔ 2mm hex wrench

✔ 2.5mm hex wrench

✔ Needlenose pliers

✔ Double sided servo tape (DTXR1215)

BRUSHLESS

SPEED KIT

INSTALLATION INSTRUCTIONS

Thank you for purchasing the Dromida Brushless

Speed Kit. It is strongly recommended to completely

read this manual before use. Damage resulting from

misuse or modification will void your warranty.

1. REMOVE STEERING LINKAGE

Using needlenose pliers, remove

the steering linkage from the

servo and the steering bellcrank.

2. REMOVE 2N1

Remove the 2N1 assembly

from the chassis.

Unplug motor connector.

Remove antenna tube

from mount and slide

antenna through upper

chassis brace. Carefully

cut the tie wrap making

sure no wires are cut.

3. REMOVE UPPER CHASSIS BRACE

Remove the upper chassis

brace and spur gear cover

from the chassis.

Summary of content (5 pages)

PAGE 1
BRUSHLESS SPEED KIT INSTALLATION INSTRUCTIONS Thank you for purchasing the Dromida Brushless Speed Kit. It is strongly recommended to completely read this manual before use. Damage resulting from misuse or modification will void your warranty. REQUIRED TOOLS The following items are needed to install your Speed Kit. ✔ Phillips head screw driver ✔ 3/16" nut driver ✔ 1.5mm hex wrench ✔ 2mm hex wrench ✔ 2.5mm hex wrench ✔ Needlenose pliers ✔ Double sided servo tape (DTXR1215) 1.
PAGE 2
4. REMOVE MOTOR Remove the motor assembly from the chassis. Remove the set screw from the pinion for use later. Remove the motor mount from the motor. Save the washers. 5. REMOVE RIGHT SIDE TIE ROD Remove the right side tie rod from the bellcrank. 6. REMOVE BELLCRANK Remove the screw and then slide the right side steering bellcrank off of the shaft. Remove the ball stud from bellcrank for use later.
PAGE 3
7. INSTALL NEW BELLCRANK Slide the bellcrank onto the shaft. Attach the steering drag link using the screw removed in step 6. Install the ball stud removed in step 6. Snap the tie rod end that was removed in step 5 onto the bellcrank. 8. INSTALLING BRUSHLESS MOTOR Install the pinion onto the motor using the set screw removed in step 4. Make sure that the pinion set screw seats on the flat side.
PAGE 4
10. RE-INSTALL SPUR GEAR COVER AND BRACE Re-install the motor guard and upper chassis brace. 11. SERVO ASSEMBLY INSTALLATION Remove the servo from the 2N1 unit. Install the servo mount and servo to the chassis using original screws. 12. STEERING LINKAGE Install the brushless speed kit steering linkage by snapping it onto the balls. Make sure that the bellcrank shafts remain seated in the chassis.
PAGE 5
13. ESC INSTALLATION Clean both the bottom of ESC and chassis with alcohol. Using double sided tape, attach ESC to chassis as shown. Connect the ESC to the motor. Refer to the ESC instructions for setting up ESC. 14. RECEIVER INSTALLATION Clean both the bottom of the receiver and the chassis brace with alcohol. Install the receiver onto the upper chassis brace using double-sided tape. Plug ESC into CH2 and servo into CH1 of the receiver.