BEFORE FLYING, PLEASE READ & UNDERSTAND THESE INSTRUCTIONS! and go to www.knowbeforeyoufly.org Radio Controlled Quadcopter (4) AAA Spare Blades Batteries (2 black, 2 color) Controller Dromida Hovershot Quadcopter Screwdriver Flight Battery Memory Card TO PREVENT MOTOR DAMAGE ALWAYS BE SURE THE THROTTLE IS OFF WHEN THE BLADES ARE OBSTRUCTED OR CONTROL IS LOST.
INSTALL BATTERIES IN THE CONTROLLER HOW to FLY Remove the screw and slide the cover down to insert the included 4 AAA batteries. CHARGING Plug charger into USB port or AC adapter (DIDP1125 not included) as shown and connect the battery. The red LED will flash slowly while the battery is charging. The LED will ill be steady when the battery is fully charged. ● NEVER leave the battery unattended ttended while charging.
FLIPS USING THE DRONEVIEW APP To flip the Hovershot The DroneView app is free software for your WiFi-capable Apple or Android device that allows you to connect to the DroneView camera to use the FPV (First Person View) function as well as to take videos and pictures and upload and view them directly to your device. 1. Install the “DroneView” app from Google Play (Android) or the App Store (Apple).' 1. Press down on the left stick until the controller beeps once. 2.
When you have confirmed that the files ha ve been successfully transferred to your device’s camera roll, press Select and choose the files you wish to delete if you no longer want them in the file gallery. SETTINGS The settings menu allows you to change the WiFi name, adjust brightness and contrast, date code, resolution mode, and rotate camera view. 6. Once connected you will see on your device the image seen by the camera (referred to in this manual as the FPV feed).
PROBLEM: Stabilization not working properly. SOLUTION: (1) Battery voltage low. (2) Re-link. (3) Recalibrate the sensors. CALIBRATION If the quadcopter is constantly drifting in the same direction or the quad is not maintaining altitude, or any time a new flight control board has been installed, the sensors on the Hovershot should be calibrated. PROBLEM: Will not take off. SOLUTION: Rotor blades incorrectly installed. See Blade Replacement section. 1. Calibrate the sensors before the first flight.
CAMERA REPLACEMENT • You must check the operation of the model before every flight to ensure that the model has remained structurally sound. 1. Remove the Hovershot body. Please refer to the Control Board Replacement section for details. • Do not alter or modify the model, as doing so may result in an unsafe or unflyable model. 2. Unplug the camera cable. 3. Remove the 2 screws that secure the lens assembly to the body. • Do your part in preserving the integrity of the FPV hobby. Know 4.
STATEMENTS: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired changes or modifications not expressly approved by the party responsible for compliance and could void the user’s authority to operate the equipment.
REPLACEMENT PARTS 1 2 2 2 3 4 5 6 7 8 9 10 11 12 DIDE1276 DIDE1277 DIDE1502 DIDE1552 DIDE1278 DIDE1279 DIDE1280 DIDE1281 DIDE1283 DIDE1282 DIDE1284 DIDE1275 DIDE1285 TACZ1010 DIDE1511 Canopy Prop Set Prop Set Black/White Prop Set Black/Yellow 720p Camera Assembly Prop Guards E-Board Main Frame Main Motor CCW R/F, L/R Main Motor CW L/F, R/R Landing Feet Motor Covers LiPo 1S 3.
