User manual

CHARGING
Plug the charger into any USB port on a computer
or to a USB to AC adapter (not included, use part
DIDP1125 as an optional accessory). The LED
on the charger will illuminate solid red while the
battery is charging. The red LED will go out when
charging is complete.
NEVER
leave the battery unattended while
charging.
DO NOT
allow the USB port to power down
while the charger is connected to the battery.
ALWAYS unplug the charger from the USB port
and the battery when charging is complete.
NEVER charge a puffed or damaged battery.
CONTROLLER SETUP
Remove the
battery cover
to insert the
included (4)
AA batteries.
Reinstall
the battery
cover.
LINKING
1. Turn on the
controller with
the left stick at
its lowest
position. The
LED on the
controller will
ash, indicating
it is waiting for
the arming
sequence.
2. Slide the
flight battery
into the slot on
the underside
of the Verso.
Connect the
ight battery to
the Verso and
place it upright on a level surface. The LEDs on
the quad will  ash rapidly while the quad is linking
to the controller. Then they will blink slowly while
it waits for the arming routine.
3. In order to arm
the Verso you must
move the throttle
stick to full throttle
and then back
down to the lowest
position. The LEDs
on the quad will go
solid. The Verso is
now armed and
ready to  y.
1
2
BEFORE FLYING, PLEASE READ AND
UNDERSTAND THESE INSTRUCTIONS!
and go to www.knowbeforeyoufly.org
Radio Controlled
Quadcopter
TO PREVENT MOTOR
DAMAGE ALWAYS BE
SURE THE THROTTLE
IS OFF WHEN
THE BLADES ARE
OBSTRUCTED OR
CONTROL IS LOST.
Verso Quadcopter
Flight Battery
Spare
Blades
(2 color,
2 black)
AA Batteries (4)
Controller
Thumb Pads
USB Charger

Summary of content (4 pages)