User Manual

ManualsBrandsDromida ManualsToysKodo Manual

Radio Controlled

Quadcopter

™

Radio

2G Memory Card

USB Card

Reader

Rotor Blade Guards

AAA Batteries (2)

USB Charge

Cord

Spare Blades

(2 black, 2 white)

Flight Battery

KODO Quadcopter

CHARGING THE FLIGHT BATTERY

• NEVER leave the battery unattended while

charging.

• DO NOT allow the USB port to power down

while the charger is connected to the battery.

• ALWAYS unplug the charger from the USB port

and the battery when charging is complete.

Plug the charger into a USB to AC adapter

or USB port on a computer as shown

and connect the battery. The red LED

will flash slowly while charging and be

steady when the charge is complete.

RADIO SETUP

PROP GUARD INSTALLATION

Remove the screw on the

battery compartment cover.

Take the cover off and insert

2 AAA batteries.

1. Carefully pry off the prop

using a screwdriver.

NOTE: Do one corner at a time so you

don’t accidentally mix up the props

2. Push the prop guard in place.

3. Push the prop onto the motor

so it is tight on the shaft.

To protect the propellers from crash damage, attach

the prop guards before flight.

RADIO

For Mode 1 operation, slide the mode

switch to the MD1 position and hold the

controller with the throttle on the right side.

For Mode 2 operation, slide the mode

switch to the MD2 position and hold the

controller with the throttle on the left side.

Summary of content (3 pages)

PAGE 1
™ Radio AAA Batteries (2) Radio Controlled Quadcopter Flight Battery Rotor Blade Guards KODO Quadcopter USB Card Reader 2G Memory Card USB Charge Cord Spare Blades (2 black, 2 white) RADIO For Mode 2 operation, slide the mode switch to the MD2 position and hold the controller with the throttle on the left side. For Mode 1 operation, slide the mode switch to the MD1 position and hold the controller with the throttle on the right side.
PAGE 2
PREPARING TO FLY Your KODO is fitted with a Power-On failsafe. This is designed to ensure that the motors will not start until the KODO has detected the controller. 1. Move the throttle stick to the lowest position. Power on the controller. (Mode 2 shown.) 2. Place the KODO on a level surface and connect the battery. Do not move the KODO until you hear two beeps and the LEDs have stopped flashing. 3. Advance the throttle to the highest position. The controller will beep once. 4.
PAGE 3
TROUBLESHOOTING BLADE REPLACEMENT PROBLEM: The quadcopter will not respond to the radio. SOLUTION: (1) Turn off the radio and disconnect the battery for the KODO. Re-link the quadcopter and radio. (2) Make sure that the battery on the KODO is fully charged. NOTE: Rotor blades must be installed as shown. FRONT White Blades, Blue LEDs PROBLEM: Red radio LED light flashing after linking. SOLUTION: Replace with new AAA batteries. PROBLEM: KODO will not stay level.