Vantage FPV Headset INSTRUCTION MANUAL Model No.
Read the entire instruction manual to become familiar with the features of the product before operating. Failure to operate the product correctly can result in damage of the product, personal property and cause serious injury.
Introduction Thank you for purchasing the RC Logger Vantage FPV Headset. We hope that you will fully enjoy the immersive experience of the first person view world. The Vantage headset is light weight and super comfortable. Offering a 5" monitor, floating rear mounted battery pouch for optimum weight distribution, soft sponge rubber facial foam liner and a one piece plastic molded shell with space for those with prescription glasses, the headset packs in a lot of well thought out details.
Parts Identification Adjustable head strap VIDEO IN MENU + Battery holder Position adjustment for magnifying lens Power connector Adjustable head strap (velcro) Charging the battery Please use Charger 89155RC (sold separately) to charge up the provided battery pack. The charger’s default setting is 2S. Connect the provided battery pack to the charger’s 5624 connector as shown below.
Power On the Goggle Before using the goggle, make sure the battery pack is fully charged. Slip the goggle's power cable through the head strap’s pocket. Using provided AV cable, connect the goggle to your video source. AV cable Video source Connect the provided battery pack (89152RC) with the 5624 power cable (you can also use your own 2S / 3S battery with the provided XT60 power cable).
Focus adjustment Once the power cable is connected to the battery, the goggle will be turned on. To adjust your focus, you can move the slider on 2 sides to adjust the magnifying lens position. OSD The goggle’s OSD Menu displays the following adjustments.
1) Brightness When “BRIGHT” is shown on OSD, press the “+” or “-” button to adjust the brightness. After adjusting the brightness level, it will be saved automatically. Factory default setting is 50 2) Contrast When “CONTRAST” is shown on OSD, press the “+” or “-” button to adjust the contrast. After adjusting the contrast level, it will be saved automatically. Factory default setting is 50 3) Color When “COLOR” is shown on OSD, press the “+” or “-” button to adjust the color.
5) OSD’s Vertical Position When “MENU VP” is shown on OSD, press the “+” or “-” button to adjust the vertical position of OSD. After adjusting the OSD position, it will be saved automatically. There are 12 adjustable vertical levels. “1" is at the bottom. “12" is at the top. Below are some examples: Factory default setting is “1" (at the bottom) 6) Reset When “RESET” is shown on OSD, press the “+” or “-” button to restore factory default screen setting.
Replacing Fresnel lens 1 piece of spare Fresnel lens is included in this package. In case you need to replace the lens, please follow below steps: * Textured side of the lens always facing the monitor Slip the lens into the frame corners.
Trouble Shooting Symptom Possible cause Solution Cannot turn on the goggle The battery pack is not connected properly Check battery and wire connections The battery pack is discharged Install a charged battery pack The battery pack is dead Install a new and charged battery pack The battery pack is not connected properly Install the battery pack correctly The AV cable is not connected properly Install the AV connection correctly The AV cable is dead Get a replacement AV cable The battery pack
Spare Fresnel lens x 1pc 5624 power cable x 1pc XT60 power cable x 1pc AV cable x 1pc Battery pack x 1pc
