Owner's Manual

11
• Users can use a power bank or a car charger to charge the battery.
Insert the battery into the charger, and use the USB cable to connect the
charger to the power bank or car charger to begin charging.
• The adapter can only be used below 2000m above sea level.
• DBUS1 must be turned on to be able to connect to your computer.
• DBUS1 Micro-USB port can only be connected to data communication
ports, do not connect it to power sources like power banks.
Camera
The DBUS1 is equipped with a professional high definition camera -
SONY IMX 214,13MP, that supports 4K and 1920x1080 video shooting.
DBUS1 is equipped with electronic image stabilization (EIS), which
reduces or eliminates vibration in images. With EIS, photos are saved to
the built-in memory with a resolution up to 2880 x 1620 at 96 dpi / 24 bit
depth. Videos are stabilized at a resolution of 1920 x 1080p at 30 fps.
EIS may be switched off.
Signal Frequency
The drone uses 5.8GHz. Different versions may connect with a mobile
device at different frequencies. Please check the aircraft frequency from
the package.
Micro-USB Port
While DBUS1 is turned on, use the provided USB cable to connect
DBUS1 to your computer. You can then copy your photos and videos
onto your computer.
Reset Button
To reset the Wi-Fi, default SSID and password, hold down the Reset
Button on the base of the drone for 3 seconds until the Aircraft Status
Indicator finishes blue:
• SSID : DBUS1-XXXXXX.
(Labeled beside the battery compartment on the base of the aircraft, the
XXXXXX is THE LAST 6 alphanumeric digits of the Wi-Fi’s MAC address)
• Password : dronesbyus (all lower case)