Owner's Manual

Features
5
DBUS1 principally consists of five systems: flight, positioning,
communications, power supply and the camera system. This section
will explain the functions of each.
On/Off Switch and Power Indicator
The On/Off Switch has a built in Power Indicator. Hold the On/Off Switch
for 3 seconds. Wait until the Power Indicator shows solid green, then
remove your finger and DBUS1 will switch on. After a few seconds,
DBUS1 will sound, alerting you that the ESC has turned on. After
connecting to the app, the Power Indicator will flash green. Hold the
On/Off Switch for 3 seconds. Wait until the blue light of the Power
Indicator goes out, then remove your finger and DBUS1 will switch off.
Drone Status Indicator
On the tail of the aircraft, there’s an RGB indicator that shows the status
of DBUS1 The Status Indicator’s colors and corresponding meanings
are as follows:
GPS Positioning
DBUS1 uses a GPS & GLONASS dual-mode satellite positioning
system. The satellite positioning system is GPS based, with GLONASS
acting as a supplementary system. During outdoor flights, DBUS1 uses
GPS positioning when the number of identified satellites ≥8.
Indicator
Color Meaning
Normal Status
Assistant Prompts
Warning and Abnormal Status
Slow Green Flashing
Green Double Flash
Solid Light Blue
Light Blue Double Flash
Solid Blue
Blue Double Flash
Solid Blue for 3s
Red Double Flash
Slow Red Flashing
Solid Red
Light Off
Red-Blue Alternate Flashing
Critical Battery Warning
Low Battery Warning
No-Fly Zone Warning
GPS Failure
Other Failure
Horizontal Compass Calibration successful
Horizontal Compass Calibration not successful
Vertical Compass Calibration successful
Vertical Compass Calibration not successful
Hold and Power Off
Normal Status
Optical Flow and Ultrasonic Positioning