User Manual

BST Testing (Shenzhen) Co.,Ltd. Report No.: BSTXD200414607301ER
Add: No.7, New Era Industrial Zone, Guantian, Bao'an District, Shenzhen, Guangdong, China
Certificate Search: http://www.bst-lab.com, Tel:[phone], E-mail:[e-mail]
Page 14 of 36
6.5.Operating Condition of EUT
6.5.1.Setup the EUT as shown on Section 6.1.
6.5.2.Turn on the power of all equipments.
6.5.3.Let the EUT work in test mode (ON) and measure it.
6.6.Test Procedure
The EUT is placed on a turn table which is 0.8 meter above ground. The turn table can
rotate 360 degrees to determine the position of the maximum emission level. The EUT is
set 3 meters away from the receiving antenna which is mounted on a antenna tower. The
antenna can move up and down between 1 to 4 meters to find out the maximum emission
level. Broadband antenna (calibrated by dipole antenna) are used as a receiving antenna.
Both horizontal and vertical polarization of the antenna are set on test.
The bandwidth setting on the test receiver is 120 KHz.
The EUT is tested in Semi-Anechoic Chamber. and all the scanning waveform is put in
Appendix II.
6.7.Test Results
PASS.