User Manual
Table Of Contents
- TEST REPORT DECLARATION
- 1.TEST RESULTS SUMMARY
- 2.GENERAL INFORMATION
- 3.PRODUCT DESCRIPTION
- 4.TEST EQUIPMENT USED
- 5.POWER LINE CONDUCTED EMISSION TEST
- 6.RADIATED EMISSION TEST
- 7.HARMONIC CURRENT EMISSION TEST
- 8.VOLTAGE FLUCTUATIONS & FLICKER TEST
- 9.ELECTROSTATIC DISCHARGE TEST
- 10.ELECTRICAL FAST TRANSIENT/BURST TEST
- 11.SURGE TEST
- 12.VOLTAGE DIPS AND INTERRUPTIONS TEST
- APPENDIX I
- APPENDIX II
BST Testing (Shenzhen) Co.,Ltd. Report No.: BSTXD200414607301ER
Add: No.7, New Era Industrial Zone, Guantian, Bao'an District, Shenzhen, Guangdong, China
Certificate Search: http://www.bst-lab.com, Tel:400-882-9628, 8009990305, E-mail:christina@bst-lab.com
Page 25 of 36
11.6.Test Procedure
1) Setup the EUT and test generator as shown on Section 12.1.
2) For line to line coupling mode, provide a 1.0KV 1.2/50us voltage surge (at open-circuit
condition) and 8/20us current surge to EUT selected points.
3) At least 5 positive and 5 negative (polarity) tests with a maximum 1/min repetition rate are
conducted during test.
4) Different phase angles are done individually.
5) Record the EUT operating situation during compliance test and decide the EUT immunity
criterion for above each test.
11.7.Test Results
PASS.
Please refer to the following page.